Where hostname is the device name of a printer server, the ht=1 tag specifies the hardware type is
Ethernet, the ha= tag specifies the Ethernet address of a printer server, which is the Node ID
located on the printer server. The ha tag must be preceded by the ht tag. The ip= tag should
correspond to the IP address you want to assign to the printer server.
For example, a printer server with the following configuration:
Node ID: 0000B4010101 (this implies Ethernet
address is 0000B4010101),
IP address: 203.66.191.12
The entry for this printer server in the /etc/bootptab file should be:
PS010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12:
56
To Next Page
Loading...
