User Manual for BPS-i30
www.levitronix.com
PL-4042-00, Rev05, DCO# 21-057
1 Safety Precautions
The BPS-i30 pump system is designed to be used in industrial production machines and equipment containing
hydraulic circuits. Typical applications are Semiconductor and chemical manufacturing equipment. Installation
shall be done by qualified personnel only. Following safety precautions and all “CAUTION”, “WARNING” and
“DANGER” indications in the relevant sections shall be followed.
Do not under any circumstances open the driver. Levitronix
®
does not assume
responsibility for any damage, which occurs under such circumstances.
High magnetic field strength of pump impeller.
The pump system contains a rotor magnet with high field strength. This may alter
or damage the calibration of sensitive electronic devices and measuring
instruments in the immediate surroundings. Keep at a safe distance from
computers, monitors and all magnetic data storage media (e.g. disks, credit
cards, audio and video tapes etc.)
Hazardous voltage may be present.
In case of the usage of an inadequate AC/DC power supply, mains voltages may
be present (even if the system is designed for up to 24 VDC). The usage of a
galvanic separated power supply, which is certified by a 3
rd
party (UL or CE), is
highly recommended.
Do not under any circumstances open the powered driver.
High magnetic field strength of pump impeller.
The pump system contains a rotor magnet with high field strength. Pacemakers
may be influenced and magnetic forces may lead to contusions. Keep distance
to pacemakers and handle impeller with care.
TOXIC CHEMICALS may be present.
When using the system to pump chemicals skin contact and toxic gases may be
hazardous to your health. Wear safety gloves and other appropriate safety
equipment.
Pump Driver for ATEX / IECEX applications.
Only specific types of integrated Pump Drivers are classified for the use in Ex
classified locations. Refer to the corresponding section in the manual.
To Next Page
Loading...
Need help?
General
