3-13
Editing
Effect Order
Ord p=C=e=m=D=R
Selecting Effect Order from the Edit menu allows you to put the six MPX 1 Effect
blocks in any order you wish. Press > to display the current ordering and routing
configuration. An ordering display such as the one shown below will appear.
An underscore identifies the Effect block which
is selected for moving to a new location.
Effect types are represented by their initial letters. Upper case
letters indicate that the Effect is active in the current program.
Lower case letter indicate that the Effect is inactive.
Each Effect block is represented by a single letter, upper case if the Effect is
active in the current program, lower case if it is not. The symbols between each
letter indicate the current routing connection options. An underscore identifies
the Effect block that is currently selected for repositioning. (In the example
shown above, the Chorus block is selected.) To move the selected block to a new
position, simply turn the knob. Use the < and >buttons to select (underscore) a
different Effect block for repositioning.
Using the same example, turn the knob two clicks to the right to move the Chorus
block and alter the Effect Order as shown below.
Press Edit to return to the main Edit menu.
Ord p=e=C=m=D=R
Ord p=e=m=C=D=R
Turn the knob one click to the right to
swap the Chorus block with the EQ
block.
Turn the knob one more click to the
right to move the Chorus block an-
other step to the right.
Ord p=C=e=m=D=R
The Chorus block is selected for
repositioning.
To Next Page
Loading...
Need help?
General
