4-7
Patching
If you create two or more patches with the same Destination, the Destination
value will be the sum of all patches assigned to it.
For example, if a Footpedal, and the knob are both assigned to Mstr Mix, the Mix
value will be the sum of the patch Destination values for those two patches.
When creating multiple patches to the same Destination, you should set the
individual Destinations to values which, when added together, are less than or
equal to the maximum value for each parameter. The Footpedal and the knob,
for example, could each have a maximum value of 50%, or they could be
assigned values of 25% and 75%, 60% and 40%, etc.
When the sum of multiple patched parameter Destination values is greater than
the maximum value of the parameter, the parameter value will remain at
maximum until the sum of the patches falls below it.
Multiple Patches with
the Same Destination
Suspending and
Clearing Patches
Continuing to press > will step you to the Suspend option. Selecting Suspend
temporaily suspends the patch until such time as you return to the Patch System
Destination Option and select Unsuspend.
Continuing to press > will step you to the options: Clear 1-5, and Clear All. These
allow you to select any or all patches to be cleared.
Once you have made any selection, press Options to have your choice take
effect and to return to the Source and Destination Assignment screen.
To Next Page
Loading...
Need help?
General
