Disabling the AppleTalk protocol
IP is the only network protocol permitted under this evaluation. The AppleTalk protocol must be disabled.
Using the EWS
Note: For information about accessing the EWS, see “Using the Embedded Web Server” on page 15.
1 From the Embedded Web Server, click Settings > Network/Ports > AppleTalk.
2 Verify that the Activate check box is cleared, and then click Submit.
Using the touch screen
1
From the home screen, touch > Network/Ports > Standard Network > STD NET SETUP.
2 From the Std Network Setup screen, touch AppleTalk > Activate.
Note: It might be necessary to scroll down to find the AppleTalk selection.
3 Set Activate to No.
4 Touch Submit. The MFP will return to the AppleTalk screen. From there you can touch Back to return to the Std
Network Setup screen or the home icon to return to the home screen.
Shutting down port access
Disabling virtual ports helps prevent intruders from accessing the MFP using a network connection. For information
about accessing the EWS, see “Using the Embedded Web Server” on page 15.
1 From the Embedded Web Server, click Settings > Security > TCP/IP Port Access.
2 Clear the following check boxes:
• TCP 21 (FTP)
• UDP 69 (TFTP)
• TCP 79 (FINGER)
• UDP 161 (SNMP)
• TCP 631 (IPP)
• TCP 5000 (XML)
• TCP 5001 (IPDS)
• TCP 6110/UDP6100/TCP6100
• TCP 9000 (Telnet)
• UDP 9300/UDP 9301/UDP 9302 (NPAP)
• TCP 9500/TCP 9501 (NPAP)
• TCP 9600 (IPDS)
• UDP 9700 (Plug‑n‑Print)
• TCP 10000 (Telnet)
• ThinPrint
• TCP 65002 (WSD Print Service)
• TCP 65004 (WSD Scan Service)
18
To Next Page
Loading...
Need help?
General