3 Verify that the MFP is in Configuration mode by locating the Exit Config Menu icon in the lower right corner of the
touch screen.
4 Scroll through the configuration menus to locate the Disk Encryption menu selection.
5 Touch Disk Encryption > Enable.
Warning: Enabling disk encryption will erase the contents of the hard disk.
6 The following message appears: Contents will be lost. Continue?
• Touch Yes to proceed with disk wiping and encryption. A status bar will indicate the progress of the encryption
task. Disk encryption can take several hours to complete.
After the disk has been encrypted, the MFP will return to the Enable/Disable screen.
Warning: Do not turn off the device during the encryption process. Doing so may result in loss of data.
7 Touch Back, and then touch Exit Config Menu.
The MFP will undergo a power‑on reset, and then return to normal operating mode.
Disabling the USB buffer
Disabling the USB buffer disables the USB host port on the back of the device.
1 From the home screen, touch > Network/Ports > Standard USB.
2 Set USB Buffer to Disabled.
3 Touch Submit.
8
To Next Page
Loading...
Need help?
General