Overview and first steps
Overview
This guide describes how to configure a supported Lexmark
TM
multifunction printer (MFP) to reach Common Criteria
Evaluation Assurance Level 2 (EAL 2). It is critical that you carefully follow the instructions in this guide, as failure to do
so may result in a device that does not meet the requirements of the evaluation.
Using this guide
This guide is intended for use by Lexmark service providers, and network administrators responsible for the
management of security appliances and software in their network environment. A working knowledge of Lexmark
multifunction printers is required for effective use of this guide.
Some settings can be configured using either the Embedded Web Server (EWS), or the device touch screen. Where
applicable, instructions for both methods are included.
For information about physically setting up the MFP or using device features, see the User Guide that came with your
MFP. For information about using the MFP touch screen, see“Appendix A: Using the touch screen” on page 44.
Supported devices
This guide describes how to implement an evaluated configuration on the following models:
• Lexmark X548
• Lexmark XS548
• Lexmark X792
• Lexmark XS796
• Lexmark X925
• Lexmark XS925
• Lexmark X950
• Lexmark X952
• Lexmark X954
• Lexmark XS955
• Lexmark 6500e scanner with T650 printer
• Lexmark 6500e scanner with T652 printer
• Lexmark 6500e scanner with T654 printer
• Lexmark 6500e scanner with T656 printer
Note: If you are using a Lexmark 6500e scanner with a T650, T652, T654, or T656 printer, then you must complete
the setup and configuration steps in the Setup Guide that came with the scanner before following the instructions in
this guide.
5
To Next Page
Loading...
Need help?
General