64
Removing and reinstalling the software
If the All-In-One software is not functioning properly or a communications
error message appears, you may need to remove and then reinstall the
All-In-One software.
Note: Before reinstalling, shut down and restart the computer.
If the problems persist, follow these steps:
1 From the desktop, click Start Æ Programs Æ
Lexmark 2300 Series Æ Uninstall.
2 Follow the instructions on the computer screen to remove the
All-In-One software.
3 Restart the computer.
4 Click Cancel on any Add New Hardware screens.
5 Eject and reinsert the software CD.
If the All-In-One software installation screen does not appear:
a From the desktop, double-click My Computer.
For Windows XP, click Start to access the My Computer icon.
b Double-click the CD-ROM drive icon. If necessary, double-click
setup.exe.
c When the All-In-One software installation screen appears, click
Install or Install Now.
d Follow the instructions on the computer screen to complete the
installation.
To Next Page
Loading...
