4-12 Service Manual
5025-2xx, 4xx
Top cover assembly removal
See “Top cover assembly” on page 7-3 for the part number.
1. Remove the right cover assembly. See “Right cover assembly removal” on page 4-10.
2. Remove the waste toner bottle. See “Waste toner bottle removal” on page 4-60.
3. Remove the imaging unit. See “Imaging unit (IU) removal” on page 4-35.
4. Remove the rear shield. See “Rear shield removal” on page 4-11.
5. Disconnect the fan cable from JFAN1 (A) on the controller board.
6. Remove the screw (B).
7. Lift the exit deflector, and remove the screw (C) holding the ground cable.
To Next Page
Loading...
