Repair information 4-15
5025-2xx, 4xx
Autocompensator mechanism (ACM) removal—standard tray
See “Autocompensator mechanism (ACM)—standard tray” on page 7-5 for the part number.
1. Remove the toner cartridges, the waste toner bottle, and the imaging unit (IU). See “Waste toner bottle
removal” on page 4-60, and see “Imaging unit (IU) removal” on page 4-35.
2. Remove the left cover. See “Left cover assembly removal” on page 4-6.
3. Remove the rear shield. See “Rear shield removal” on page 4-11.
4. Disconnect the autocompensator mechanism (ACM) cable connector (A) from the controller board.
5. Pull the cable (B) through the opening, and free the cables from the retainers (C) on the left side.
To Next Page
Loading...
