Repair information 4-31
5025-2xx, 4xx
High-voltage power supply (HVPS) assembly removal
See “High-voltage power supply” on page 7-7 for the part number.
Note: This removal requires a magnetized, long-shank Phillips screwdriver at least 8 in. or 200 mm long.
1. Remove the top cover assembly. See “Top cover assembly removal” on page 4-12.
2. Remove the rear shield. See “Rear shield removal” on page 4-11.
3. Remove the cable cover (A).
4. Disconnect the high-voltage power supply (HVPS) cable at the HVPS and at the controller board.
To Next Page
Loading...
