4-18 Service Manual
5025-2xx, 4xx
Bin full sensor removal
See “Photo sensor” on page 7-7 for the part number.
1. Open the front cover.
2. Remove the bin full sensor flag. See “Bin full sensor flag and exit deflector removal” on page 4-18.
3. Remove the cable from the retainer.
Note: Be sure to note the routing for re-installation.
4. Disconnect the cable (A) from the bin full sensor.
5. Gently remove the sensor from the bracket by hand.
Installation notes:
1. Guide the latches that hold the sensor in the bracket into place.
2. Squeeze the latches together until they fit into place
3. Reconnect the cable, and reroute the cable through the retainer.
Bin full sensor flag and exit deflector removal
The bin full sensor flag and the exit deflector are in the same FRU. See “Exit deflector and bin full sensor flag
removal” on page 4-24.
To Next Page
Loading...
