Repair information 4-49
5025-2xx, 4xx
Installation notes:
Install the new rubber tires with the surface texture turning in the direction as shown.
Note: Feel each rubber surface to verify it turns properly in the direction shown. The smoother surface pushes
the paper toward the front of the printer.
Printhead removal
See “Printhead” on page 7-5 for the part number.
1. Remove the top cover. See “Top cover assembly removal” on page 4-12.
2. Disconnect the cables from the controller board.
Note: Be very careful disconnecting handling the ribbon cable.
3. Remove the toroid (A) from the ribbon cable.
Note: Be sure to replace the toroid on the cable when you reinstall the printhead.
To Next Page
Loading...
