Diagnostic information 2-41
5025-2xx, 4xx
Operator panel display is dim and unchanging
Step Questions / actions Yes No
1 Turn the printer off, and remove the rear
shield. See “Rear shield removal” on
page 4-11.
Turn the printer on, and verify the following
values at JOPP1 on the controller board:
Are all these values approximately correct?
Go to step 2. Replace the controller
board. See “Controller
board removal” on
page 4-19.
2
Check for continuity in the operator panel
cable connector.
Note: Remove the three screws holding the
operator panel, and place it facedown on top of
the printer. The cable connector pins will be
exposed and easier to contact.
Do all the conductors indicate continuity?
Replace the operator panel.
See “Operator panel
removal” on page 4-9.
Replace the front cover
assembly. See “Front
cover assembly removal”
on page 4-2.
JOPP1
Pin Value
10 V dc
2 +5 V dc
30 V dc
4 Ground
5 +5 V dc
6 +3.3 V dc
7 Ground
To Next Page
Loading...
