Repair information 4-41
5025-2xx, 4xx
12. Remove the screw (G) above the frame.
13. Swing the left lower frame away from the printer, and remove.
Right lower frame
1.
Open the front cover.
2. Remove the right cover assembly. See “Right cover assembly removal” on page 4-10.
3. Remove the waste toner bottle. See “Waste toner bottle removal” on page 4-60.
4. Remove the imaging unit. See “Imaging unit (IU) removal” on page 4-35.
5. Remove the rear shield. See “Rear shield removal” on page 4-11.
6. Remove the rear screw (A) in the waste toner bottle sensor contact to allow access to the cable cover.
Note: The waste toner bottle sensor contact does not need to be unplugged.
To Next Page
Loading...
