4-128 Service Manual
5026
d. Replace all the screws (G) from the left side of the printer, including:
• Ethernet port connector (1 screws)
• Modem shield (1 screws)
• Hard disk shield (2 screws)
• Ground screw (1 screw)
Note: Be sure to attach the ground wire (H) to the ground screw.
e. Reconnect all the cables to the system board. Use the diagram below for a guideline.
Warning: Be careful reconnecting the printhead ribbon cable (J). It can be damaged and should be
handled carefully. A flat ribbon cable can easily be damaged and should be connected gently by hand.
f. Install the hard disk if appropriate.
To Next Page
Loading...
