Lexmark C734 - Page 431

Index I-5
5026
top access cover assembly
4-40
top cover 4-43
covers, rear upper cover 4-36
display detent spring 4-63
duplex reference edge guide 4-66
electrophotographic (EP) process drive assembly 4-69
front door assembly 4-79
front door assembly restraint cable (left) 4-82
front door assembly restraint cable (right) 4-86
fuser 4-90
hard drive assembly 4-93
high-voltage power supply (HVPS) 4-94
high-voltage power supply cable 4-96
left bellcrank 4-97
low voltage power supply (LVPS) 4-98
motor driver cable 4-101
motor driver card 4-100
multipurpose feeder (MPF)/duplex motor cable 4-107
multipurpose feeder/duplex gear and housing 4-102
multipurpose feeder/duplex motor assembly 4-104
operator panel bezel 4-28
operator panel buttons 4-29
operator panel cable 4-108
operator panel ground cable 4-110
option cable 4-111
options
HCIT controller board assembly
4-170
HCIT drawer slide assembly 4-171
HCIT elevator motor with sensor 4-171
HCIT feed with bushing roller 4-169
HCIT front tray cover 4-165
HCIT left cover 4-168
HCIT media tray assembly 4-164
HCIT photointerrupter sensor with cable assembly
4-176
HCIT pick arm roll 4-173
HCIT rear cover 4-166
HCIT right cover 4-167
HCIT slide assembly with spring 4-174
HCIT top plate assembly 4-177
paper pick mechanism assembly 4-113
photoconductor unit 4-118
pick roll rubber tires 4-119
precautions 4-18
printer pad 4-120
printhead 4-121
right bellcrank 4-138
system board 4-139
system board support shield 4-143
toner level sensor 4-146
top cover camshaft assembly 4-148
transfer belt 4-154
transfer module 4-154
transport cable 4-156
transport motor cable 4-158
USB connector cable 4-159
waste toner assembly 4-160
wireless network antenna 4-161
wireless network card 4-162
Reset Color Cal 3-21
Reset Fuser Cnt 3-25
restraint cable, removal 4-82, 4-86
right cover, removal 4-37
S
safety information xv
safety inspection guide 6-1
screw and retainer identification table 4-3
SE menu 3-1
sensor tests
Dynamic Sensors
3-17
Static Sensors 3-17
sensors
bin full
7-12
exit sensor service check 2-123
input sensor service check 2-125
toner level 4-146, 7-10
serial 1 wrap test 3-13
serial number
viewing
3-20
service checks
110.xx—Mirror motor
2-37
111.xx–114.xx—printhead error 2-38
120.xx—fuser error 2-39
140.xx—Autocomp motor error 2-43
142.xx,—motor error 2-44
142.xx—fuser motor error 2-44
143.xx—motor error 2-45
144.xx—motor error 2-46
145.xx Motor Error 2-47
146.xx, 148.xx—motor error 2-48
155.xx—motor error 2-51
156.xx—motor error 2-53
160.xx, 161.xx-motor error 2-54
162.xx, 163.xx-motor error 2-55
24 V interlock switch 2-119
5 V interlock switch 2-118
906.01–90604—motor error 2-44
920.01—POST error 2-50
920.03, 920.25-transfer module 2-92
920.04—POST error 2-94
920.05—POST error 2-95
920.07—POST error 2-96
920.09—POST error 2-98
920.10—POST error 2-99
920.11—POST error 2-100
920.12—POST error 2-101
920.13—POST error 2-102
920.14—POST error 2-103
920.15, 920.20—POST error 2-104
920.16—POST error 2-105
920.17—POST error 2-106
920.18—POST error 2-107
920.19—POST error 2-108
920.21—POST error 2-109
920.23—POST error 2-111
920.27, 920.28, 920.29-POST error 2-112
925.01, 925.03, 925.05—fan error 2-112
925.02, 925.04, 925.06—blower error 2-113