Lexmark C734 - Page 64

2-30 Service Manual
5026
9xx service error messages
900.00–900.99
Software Error
(except 900.05)
Unrecoverable RIP software error. • POR the printer.
• If the error message persists, replace the
system board. See “System board removal”
on page 4-139.
900.05
Software Error.
Transfer module has failed • POR the printer.
• If the error message persists, go to “900.05—
Transfer module error service check” on
page 2-91.
902.01–902.99
Engine Software Error
(except 902.59 and
902.60)
Unrecoverable system software
errors.
• POR the printer.
• If the error message persists, replace the
system board. See “System board removal”
on page 4-139.
902.59
Error
RIP NVRAM MGR problem. POR the printer.
If the error message persists, go to “902.59—
Engine software error, NVRAM MGR problem
service check” on page 2-92.
902.60
Error
Error communicating with cartridge. 1. POR the printer.
2. If the error message persists, check for the
correct cartridges.
3. Replace the cartridges.
903.01–903.15
Engine Software Error
Unrecoverable system software
errors.
• POR the printer.
• If the error message persists, replace the
system board. See “System board removal”
on page 4-139.
904.01–904.04
Software Error
Unrecoverable system software
errors.
• POR the printer.
• If the error message persists, replace the
system board. See “System board removal”
on page 4-139.
905.00–905.99
Software Error
Unrecoverable system software
errors.
• POR the printer.
• If the error message persists, replace the
system board. See “System board removal”
on page 4-139.
910.xx
Engine Software Error
RIP software error interface violation • POR the printer.
• If the error persists, replace the system board.
See “System board removal” on page 4-139.
920.01
POST Error
Multipurpose feeder/duplex motor
assembly not connected.
• POR the printer.
• If the error message persists, go to “147.xx,
920.01—Aligner motor error service check”
on page 2-50.
920.02
POST Error
Tray 1 motor not connected. • POR the printer.
• If the error message persists, go to “140.xx,
920.02—Autocomp (tray 1) motor error
service check” on page 2-43.
920.03
POST Error
Transfer module not connected. • POR the printer.
• If the error message persists, go to “920.03,
920.25—Transfer Module Missing error
service check” on page 2-92.
Error code Description Action