2-40 Service Manual
5026
2
1. Remove the fuser. See “Fuser removal”
on page 4-90.
2. Check the AC and DC autoconnects on
both the fuser and the printer for damage.
Are the connections damaged?
Replace the appropriate
cable. See “Fuser AC
cable removal” on
page 4-91 or “Fuser DC
cable removal” on
page 4-92.
Go to step 3.
3
Replace the fuser. See “Fuser removal” on
page 4-90.
Does the error clear?
Problem resolved. Go to step 4.
4
Turn the printer off, and then remove the
fuser. Check the camshaft follower on the
right side. If the camshaft follower (A) is
above the crescent-shaped groove, it needs
to be pressed down into the proper location.
Is the camshaft follower on the right side
properly placed in the grove?
Go to step 5. Press the camshaft
follower into the grove.
Step Questions / actions Yes No
DC autoconnect
AC autoconnect
On printer
To Next Page
Loading...
