120
3
Holding the firmware card by its sides, gently pull the card completely out.
Avoid touching the metal pins on the bottom of the card.
4 Place the firmware card in its original packaging.
If you do not have the original packaging, wrap the firmware card in paper and store it in a box.
5 If you removed an option card to access the firmware card, reinstall the option card.
Removing a hard disk
1 Make sure the printer is turned off and the power cord is unplugged.
2 Complete the steps for Removing the system board access cover if it is still installed.
WARNING: Hard disks are easily damaged by static electricity. Touch something metal such as
the printer frame before you touch a hard disk.
If an option card has been installed, you need to remove the option card before removing the hard disk.
3 Pull the hard disk out of the holes on the system board. It is attached by three posts on the
mounting plate.
To Next Page
Loading...
