Lexmark C910 - Too Many Bins Attached; Too Many Disks Installed

223
58 Too Many
Bins Attached
What this message means:
•
Too many output bins are installed.
• An unsupported configuration of output bins is installed.
What you can do:
Turn off and unplug the printer. Remove or reconfigure the output bins. Plug in the printer and
turn it on.
Note: To prevent an electrical overload, plug your printer into a well-grounded outlet on a
non-ground fault interrupter (GFI) circuit.
58 Too Many
Disks Installed
What this message means:
Too many hard disks are installed. The printer only supports one hard disk at a time.
What you can do:
Turn off and unplug the printer. Remove the excess hard disks. Plug in the printer and turn it
on.
Note: To prevent an electrical overload, plug your printer into a well-grounded outlet on a
non-ground fault interrupter (GFI) circuit.
See also:
Removing memory and network options