Maintenance
4 Tighten the eight screws.
5 Connect the printer cables and power cord, and turn the printer on.
Note: To prevent an electrical overload, plug your printer into a well-grounded outlet on a
non-ground fault interrupter (GFI) circuit.
Removing an optional drawer
1 Turn the printer off.
2 Unplug the power cord.
Note: To prevent an electrical overload, plug your printer into a well-grounded outlet on a
non-ground fault interrupter (GFI) circuit.
3 Disconnect the parallel or Ethernet cable from the printer.
If you have any other devices connected to the printer, turn them off and unplug any cables
going to the printer.
CAUTION: This printer weighs 80.5 kg (177 Ib) and requires four people to lift. Anytime you
move or lift the printer make sure you have enough people to help. Use the
handholds located on the sides to lift.
4 Lift the printer and move it away from the optional drawer.
CAUTION: An optional drawer weighs 18.5 kg (40.8 Ib.). Have someone help when lifting.
Removing an optional drawer
187
To Next Page
Loading...
Need help?
General
