Message Action
Too many flash options installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to properly grounded electrical
outlet.
5 Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control panel, select Continue to
continue printing. For non‑touch‑screen printer models,
press OK to confirm.
• Format the flash memory.
Note: If the error message remains, then the flash memory
may be defective and need to be replaced.
Waste toner bottle nearly full [82.xy]
You may need to order a waste toner bottle. If necessary,
select Continue on the printer control panel to clear the
message and continue printing. For non‑touch‑screen printer
models, press OK to confirm.
Weblink server not set up. Contact system
administrator.
An error occurred on the SMTP server, or the SMTP server is
not configured properly.
From the printer control panel, touch Continue to clear the
message.
Note: If the message appears again, then contact your
system support person.
Service errors
• “1xx service error messages” on page 76
• “110.xx Printhead service check” on page 82
• “121.xx Fuser service check” on page 83
• “133.xx Toner meter sensors (Y, C, M, K) on TMC card service check” on page 87
• “141.xx—Cartridge motor error service check” on page 89
• “147.xx Paper pick motor drive assembly service check” on page 91
• “171.xx Fan error service check” on page 93
• “84x.xx service error messages” on page 94
• “840.xx service check” on page 95
• “843.xx service check” on page 96
• “ADF service check” on page 97
• “Flatbed legal scan service check” on page 98
• “9xx service error messages” on page 99
• “900.xx System software error service check” on page 103
• “91x.xx (910.xx‑919.xx) Engine software service check” on page 107
• “950.xx NVRAM failure service check” on page 108
7527
Diagnostic information
75
To Next Page
Loading...
Need help?
General
Weight and Dimensions
