Energy Conserve
Energy Conserve affects the values that appear in the Power Saver menu in the customer Setup Menu. This menu item
appears only when the printer model does not support Automatic Power Saver or has deactivated Automatic Power
Saver. Energy Conserve affects only the values that are displayed in the Power Saver menu.
Select Off in Energy Conserve to allow Power Saver in the customer menu to display Disable as an option. If Disable is
selected in the customer Power Saver, the printer deactivates the Power Saver feature. Select On (the default) in Energy
Conserve to prevent Disable from appearing as an option in the Power Saver setting, and preventing the customer
from turning off Power Saver.
Fax low power support
Fax Low Power support allows you to select one of three power settings for the fax. The Auto value relies on the
firmware’s logic to determine if the device supports the fax portion of the low power architecture. Permit Sleep allows
the fax chip to enter low power mode whenever the device determines that it should. Disable Sleep prohibits the fax
chip from ever entering low power mode.
To change the fax low power support setting:
1 Select Fax low-power support in the configuration menu to open the item
2 Select one of the three settings: disable, sleep permit or sleep auto
3 Select the check sign to accept the setting or press the X on the screen to exit the item.
Min copy memory
Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at least
200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1 Select Min Copy Memory from the Configuration Menu. [setting's current value] displays.
2 Select one of the three settings: disable, sleep permit or sleep auto
3 Select the minus to decrease the setting's value or the plus to increase the setting’s value.
4 Select Submit to save the change.
Num pad job assist
This setting determines if a user can configure and initiate a job using the operator panel’s hard buttons.
To change this setting:
1 Select Num Pad Job Assist from the Configuration Menu. [setting's current value] displays.
2 Select the minus to decrease the setting's value or the plus to increase the setting’s value.
3 Select Submit to save the change.
Format fax storage
This setting enables you to format the non-volatile storage used for storing faxes.
7527
Service menus
194
To Next Page
Loading...
Need help?
General
Weight and Dimensions
