Loading print media into Tray 1
49
Print media tasks and tips
Follow the steps below to load print media into Tray 1:
1 Open paper cover by lifting up until the cover clicks into a fully open state.
2 Adjust the slide and attached backstop to the length of the selected print media.
Note: The slide with attached backstop is a dual-action mechanism. The rectangular slide can be adjusted
in and out to allow for the multiple sizes of print media the printer supports. The attached backstop
can be adjusted in and out to fit the length of the multiple sizes of print media the printer supports.
Note: Tray 1 width can be adjusted by pushing in on the left guide. To increase the width, squeeze the tab
attached to the right guide and slide to the right until the selected media width is matched.
To Next Page
Loading...
