Loading standard trays and optional trays
58
Printing
5 Place the paper in the tray as shown, print side down.
Do not load bent or wrinkled paper.
Note: Do not exceed the maximum stack height. Overfilling the tray may cause jams.
6 Squeeze the front guide lever and slide the guide until it firmly touches the stack of paper.
7 Reinstall the tray.
Make sure the tray is pushed completely into the printer.
8 If you are loading a different type of media than was previously loaded in the tray, change the Paper Type setting
for that tray on the operator panel.
Maximum stack height indicator
To Next Page
Loading...
