Diagnostic aids 3-3
4061-xx0
DUPLEX TESTS (if installed)
Quick Test See “Quick Test (duplex)” on page 3-9
Top Margin See “Top Margin (duplex)” on page 3-10
Sensor Test See “Sensor Test (duplex)” on page 3-10
Motor Test See “Motor Test (duplex)” on page 3-11
Duplex Feed 1 See “Duplex Feed 1” on page 3-12
Duplex Feed 2 See “Duplex Feed 2” on page 3-12
INPUT TRAY TESTS
Feed Tests See “Feed Tests (input tray)” on page 3-13
Sensor Test See “Sensor Test (input tray)” on page 3-13
OUTPUT BIN TESTS
Feed Tests See “Feed Tests (output bins)” on page 3-14
Feed To All Bins See “Feed To All Bins” on page 3-14
Sensor Test See “Sensor Test (standard output bin)” on page 3-15
Diverter Test (if 5-bin
installed)
See “Diverter Test” on page 3-16
FINISHER TESTS (if installed)
Staple Test See “Staple Test” on page 3-17
Feed Tests See “Feed Tests (finisher)” on page 3-17
Sensor Test See “Sensor Test (finisher)” on page 3-17
BASE SENSOR TEST See “BASE SENSOR TEST” on page 3-18
Toner
Input
Output
DEVICE TESTS
Quick Disk Test (if installed) See “Quick Disk Test” on page 3-18
Disk Test/Clean (if installed) See “Disk Test/Clean” on page 3-19
Flash Test (if installed) See “Flash Test” on page 3-19
PRINTER SETUP
Defaults See “Defaults” on page 3-20
Page Count See “Page Count” on page 3-20
Perm Page Count See “Perm Page Count (permanent page count)” on page 3-20
Serial Number See “Serial Number” on page 3-20
Envelope Enhance See “Envelope Enhance” on page 3-20
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-20
Model Name See “Model Name” on page 3-20
Configuration ID See “Configuration ID” on page 3-21
Edge to Edge See “Edge to Edge” on page 3-21
Par S Strobe Adj See “Parallel strobe adjustment (Par x Strobe Adj)” on page 3-21
Par x Strobe Adj (if additional
parallel options are installed)
Diagnostics mode tests (continued)
To Next Page
Loading...
