4-74 Service Manual
4061-xx0
Printhead removal
CAUTION: The laser scanning unit is not a serviceable FRU. Replace the entire unit when service is required.
1. Remove the laser cover. See “Laser cover removal” on page 4-20.
2. Disconnect the printhead cable (A) from the printhead assembly.
3. Remove the three printhead mounting screws (B), and remove the printhead.
Note: Do the “Printhead assembly adjustment” on page 4-2 whenever you remove or replace the printhead
assembly or loosen the mounting screws.
To Next Page
Loading...
