4-26 Service Manual
4061-xx0
Developer drive coupler kit removal
1. Remove the developer drive. See “Developer drive assembly removal” on page 4-25.
2. Remove the shaft drive and coupler.
ESD cover removal
1. Open the multipurpose tray, and remove the tray from the two mounting posts. See “Multipurpose feeder/
lower front cover assembly removal” on page 4-16.
2. Carefully lift the latch on the left (A), and remove the ESD cover.
Note: Be careful not to stress the hinge on the right (B).
To Next Page
Loading...
