Repair information 4-53
4061-xx0
Installation
1.
Remove the new pick rolls from their packaging.
2. Pull the autocompensator arm down. Locate the recessed area on the pick roll, and align it with the tab on
the arm. There are two arrows on each pick roll. Make sure the bottom arrow faces you as you align the
recessed area with the tab.
3. Push the pick roll onto the arm with the tab aligned. Repeat this step on the other side to install the other
pick roll.
4. Gently release the autocompensator arm. Insert, integrated tray.
To Next Page
Loading...
