Lexmark X644E - Page 46

46Mainframe Installation Setup: Task 5 - Configuring the SCS/TNe Emulation
The table below shows the factory default settings and
recommended settings. The option setting values found in
the table are described in section “NETWORK SETUP>
SERVER INFO Menu: Options Overview” on page 93.
SERVER INFO
Option
Default Value Recommended Value Comments
Name / IP
Address
Use IP Address Check with your system administrator whether you need to
specify the specific IP address or the name of the host which
the printer will contact to receive SCS jobs.
IP Address 0.0.0.0 The TNe Server’s IP
address
In order to make a connection to the mainframe host, an IP
address must be entered or a hostname defined.
If you selected Use IP Address in the Name / IP Address
option, enter the appropriate IP Address here.
(This option is not used if you selected Use Hostname).
Hostname [undefined] A hostname to look
up on a DNS server:
(up to 16 characters)
In order to make a connection to the mainframe host, an IP
address must be entered or a hostname defined.
If you selected Use Hostname in the Name / IP Address
option, enter the appropriate hostname here.
(This option is not used if you selected Use IP Address.)
TN Server Port 23 23 Check with your system administrator to determine whether
another TCP port number is defined for the Telnet service.