70AS/400 and iSeries Installation Setup: Task 5 - Verifying the Host Connection
Through the http (browser) user interface: Connect to the
print server by entering the print server address as the URL.
When the print server display appears, click Reports and
then Device Setttings.
IMPORTANT:
Powering the printer Off and On does not end
TCP/IP and Telnet sessions in an orderly manner.
To power the printer Off properly, select Menus >
Option Card Menu > SCS/TNe MENU >
COMMON SETUP > Disconnect Ses >
Disconnect Ses.
See: Disconnect Ses, page 78.
3 Check the host auto configure settings. See “Task 1 -
Configuring the Host” on page 54.
To Next Page
Loading...
