280
8-3. What to do if...
New message notifications are not dis-
played.
■ In other situations
The Bluetooth
®
connection status is
displayed at the top of the screen each
time the engine switch <power switch>
is in ACCESSORY or IGNITION ON
mode <ON mode>.
Even though all conceivable measures
have been taken, the symptom status
does not change.
For details, refer to the owner’s manual that
came with the cellular phone.
Likely cause Solution
Message transfer is
not enabled on the
cellular phone.
Enable message
transfer on the cellu-
lar phone (approve
message transfer on
the phone).
Automatic transfer
function on this sys-
tem is set to off.
Set automatic con-
tact transfer func-
tion on this system to
on. (P.270)
Likely cause Solution
Notification of
SMS/MMS/E-mail
reception on this
system is set to off.
Set notification of
SMS/MMS/E-mail
reception on this
system to on.
(P.269)
Automatic message
transfer function is
not enabled on the
cellular phone.
Enable automatic
transfer function on
the cellular phone.
Likely cause Solution
Connection confir-
mation display on
this system is set to
on.
To turn off the dis-
play, set connection
confirmation display
on this system to off.
(P.54)
Likely cause Solution
The cellular phone is
not close enough to
this system.
Bring the cellular
phone closer to this
system.
Radio interference
has occurred.
Turn off Wi-Fi
®
devices or other
devices that may
emit radio waves.
The cellular phone is
the most likely cause
of the symptom.
Turn the cellular
phone off, remove
and reinstall the bat-
tery pack, and then
restart the cellular
phone.
Enable the cellular
phone’s Bluetooth
®
connection.
Stop the cellular
phone’s security
software and close
all applications.
Before using an
application installed
on the cellular
phone, carefully
check its source and
how its operation
might affect this sys-
tem.
To Next Page
Loading...
