This product has been manufactured under a quality management system certified to ISO 9001:2015
ADDITIONAL LEGISLATION AND COMPLIANCE INFORMATION
EU EMC Directive: Class A/B Industrial equipment
Caution: This equipment is not intended for use in residential environments and may not provide adequate protection to
radio reception in such environments.
EU RoHS Directive: Material Exemption Information
This product is compliant with the following Exemptions
Annex III:
• 6(a) Lead as an alloying element in steel for machining purposes and in galvanised steel containing up to 0.35 % lead
by weight
• 6(b) Lead as an alloying element in aluminium containing up to 0.4% by weight
• 6(c) Copper alloy containing up to 4% lead by weight
EU REACH Regulation Compliance
This product is a complex article which is not designed for intentional substance release. To the best of our knowledge
the materials used comply with the requirements of REACH. The product manual provides information and instruction to
ensure the safe storage, use, maintenance and disposal of the product including any substance based requirements.
Article 33.1 Declaration
This product contains Candidate List Substances of Very High Concern above 0.1%ww by article as clarified under the
2015 European Court of Justice ruling in case C-106/14.
• Lead (Pb)
This substance is present in certain steel / aluminium / brass components.
Additional Applicable Requirements
The product is in scope for and complies with the requirements of the following:
Directive on waste electrical and electronic equipment (WEEE)
Product is certified to
CSA-C22.2 No.61010-1-12
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
Product conforms to
UL61010-1 3
rd
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
To Next Page
Loading...
