8
SAFETY PRECAUTIONS
y
Store the battery away from metal ob-
jects, such as keys and paper clips.
- Excess current may cause rapid
increase in temperature, resulting in
fire or burns.
y
Do not store the battery near heat
sources, such as heaters.
- Otherwise, this may result in fire or
explosion.
y
Do not store the battery at tem-
peratures higher than 60°C or in high
humidity.
- Otherwise, it may cause explosion
or fire.
y
Keep the battery out of reach of chil-
dren.
- Otherwise, this may result in per-
sonal injury or damage to the product.
y
Make sure that the battery is nstalled
correctly.
- Otherwise, this may result in fire or
explosion.
y
The battery contains lithium ion, so
please handle with care.
- Otherwise, this may result in fire or
explosion.
y
Make sure you use the same type of
battery for replacement.
y
Incorrect battery replacement may
cause fire.
CAUTION
y
Do not mix new batteries with old
ones.
- Burst or leaking batteries are a
fire hazard or may result in electric
shock.
y
Be sure to unplug the projector if it
will not be used for a long period.
- Accumulated dust is a fire hazard
and may result in electric shock due
to overheating, ignition, or poor insu-
lation.
y
Only use the specified type of battery.
- Burst or leaking batteries are a
fire hazard or may result in electric
shock.
y
Do not stare directly into lens when in
operation, eye damage can occure.
y
No user serviceable parts inside unit.
High voltage parts can cause shock
and even electrocution.
y
Proper ventilation required, do not
block airflow around unit. Doing so
can cause injury and internal over-
heating.
y
To prevent damage to lamp, unit must
remain plugged in for approximately 3
minutes after power down to allow for
proper cool down (not applicable on
LED models).