22
OPERATING YOUR WASHER
OPERATING YOUR WASHER
❋
Do not work any button and stop the washer
(When the washer is operating) or (when a
cycle is in progress)
1. Ready mode
1) Coin / Card type
– The cycle LEDs are lit at the same time,
when the price of cycles are equal.
2) OPL type
– The cycle LEDs flash at the same time,
and displayed ‘PUSH’.
4. Custom PGM
Press and hold ‘Cold’ button for 3 seconds.
You can use courses you have created.
(Only OPL Type)
5. Change course
You cannot change the course while the
machine is running.
6 . Cycle finish
The machine stops and LED display shows
“ ” with beeper sound.
2. Insert card/coin (not for OPL type)
Insert a cash card that has a sufficient balance.
The card balance should be more than the
programmed vend price for a selected cycle.
3. Select the cycle
Press the desired button and press the
start button.
The display LED will show the remaining
time and the selected cycle starts.
• Select cycles designed for different types of
fabric and soil levels.
• Insert a sufficient amount of change that
is more than the programmed vend price
for the selected cycle.
CYCLE Wash/Rinse Temp.
90°C (194°F)
Extra Hot/Cold
75°C (167°F)
Extra Hot/Cold
60°C (140°F)
Hot/Cold
40°C (104°F)
Warm/Cold
30°C (86°F)
Warm/Cold
Cold
Cold/Cold
NOTE
• When the card balance is not enough,
machine displays the card balance for 5
seconds and then displays
message repetitively
NOTE
• The machine will not start until sufficient
coins are inserted.
WARNING
• To reduce the risk of fire, electric shock, or
injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS before operating
this appliance.
NOTE
• Price setting varies by country.
• Set your country from
mode.
(Refer
How to enter the
)
• After EEPT, reset your country. (Default
country is EUK)