52
PROGRAMMING MODE - SETUP MODE
Entering set up
mode.
You will see LqC1
Button Display
Press the
90°C (194°F)
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Display previous coin 1 value.
Press
75°C (167°F)(+)
or
60°C (140°F)(-)
button to select
value of coin 1
(The value can be set 0~1000 in 10 increments.)
Press the
Start
button.
The machine sets up the value of coin 1, then advances
to the next process automatically.
If this function is restricted originally in program,
You can move to the next step by pushing the 60°C
(140°F) button.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button twice.
19. Value of coin 1
Value of coin 1 can be used to set the incremental coin value.
NOTE
• This function is not applied for opl type.
• Price setting varies by country.
• Set your country from mode. (Refer
How to enter the
)
• After EEPT, reset your country. (Default country is EUK)
To Next Page
Loading...
Need help?
General
