70
PROGRAMMING MODE - TEST MODE
Entering set up
mode.
You will see LqC1
Button Display
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press the
75°C (167°F)
button until appears in
the display.
Set up the number you want
By pressing
75°C (167°F)
or the
60°C (140°F)
button.
For example, If you want to change password number
to No5
Press the 75°C (167°F) button until “ “ appears
in the display.
Press the
Start
button, then Password change is done.
is displayed.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button twice.
6. Password -
How to change the password.
NOTE
• Default password is 3.
If you want to change the password, you must know the present password.
To Next Page
Loading...
Need help?
General
