23
PROGRAMMING MODE
- Coin type - - Card type - - OPL type -
How to enter "Programming mode"
You can enter programming mode only for Idle
state and pause state.
- OPL/Coin/Card Type
1) Push the 90°C (194°F) & 60°C (140°F) button
at the same time.
2) Push the 75°C (167°F) button 3 times.
3) Push the Start button.
4) Display will show “ ”.
- Card type
1) Insert service card.
2) Display will show “ ”
- Coin type
1) Disassemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of
the coin box.
4) Display will show “ ”.
How to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
: You can check machine information or change setting on “Program setup”, “Collect Information
Data”, ”Diagnostic Test”.
PROGRAMMING MODE
Press Button Description
90°C (194°F)
Move to upper level or
Comes back to Idle State
75°C (167°F)
Move to the mode in the
same level (+)
60°C (140°F)
Move to the modes in the
same level (-)
Start Enter the selected mode
Coin Box Key
Insert Debit Card
Coin Vault
Openings : close
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type.
• Price setting varies by country.
• Set your country from mode. (Refer
How to enter the
)
• After EEPT, reset your country. (Default country is EUK)
To Next Page
Loading...
Need help?
General
