41
PROGRAMMING MODE - SETUP MODE
Entering set up
mode.
You will see LqC1
Button Display
Press the
90°C (194°F)
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Display .
Press the
Start
button.
Press
75°C (167°F)
or
60°C (140°F)
button and then
select or
.
One or the other will
display.
Disable
Enable
Press the
Start
button.
The machine sets up the pause function, then advances
to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button three times.
10-1. Pause function set up
Pause function setup can be used to enable/disable the ability to pause the cycle when pressing the
Start/Pause button.
To Next Page
Loading...
Need help?
General
