74
MAINTENANCE
After the cycle is finished, wipe the door and the
inside of the door seal to remove any moisture.
Leave the door open to dry the washer tub
interior. Wipe the body of the washing machine
with a dry cloth to remove any moisture
Storing the Washer
If the washer will not be used for an extended
period of time and is in an area that could be
exposed to freezing temperatures:
1. Turn off water supply tap.
2. Disconnect hoses from water supply and
drain water from hoses.
3. Plug the power cord into a properly grounded
electrical outlet.
4. Add 1 gallon of nontoxic recreational vehicle
(RV) antifreeze to the empty wash drum.
Close door.
5. Select the spin cycle and let washer spin for
1 minute to drain out all the water.
6. Unplug the power cord, dry the drum interior
with a soft cloth, and close the door.
7. Remove the inserts from the dispenser.
Drain any water in compartments and dry
the compartments.
8. Store the washer in an upright position.
9. To remove the antifreeze from the washer
after storage, run washer through a complete
cycle using detergent.
Do not add laundry!
Care after wash
MAINTENANCE
WARNING
• Unplug the washer before cleaning to
avoid the risk of electric shock. Failure
to follow this warning can cause serious
injury,fire, electric shock or death.
• Never use harsh chemicals, abrasive
cleaners, or solvents to clean the washer.
They will damage the finish.
• Do not use volatile substances (benzene,
paint thinner, alcohol, acetone, etc.) or de-
tergents with strong chemical components
when cleaning the washing machine. Doing
so may cause discoloration or damage to
the machine, or it may cause a fire.
NOTE
• Not all of the RV antifreeze will be expelled.
• Weekly cleaning of the detergent dispenser
will ensure problem free operation.
NOTE
• Do not use anything other than water
to clean the drawer, inserts, and drawer
opening.
Cleaning the Dispenser
1. The dispenser should be cleaned periodically
to remove buildup from detergent and other
laundry products.
2. Remove the inserts from the drawer, and
clean them with warm water and a soft cloth
or brush to remove any residue or buildup.
Wipe out the inside of the drawer opening
with a damp cloth. Reassemble the drawer
and reinstall in the drawer opening.
- Single model -
- Stack model -
- Single model -
- Stack model -
To Next Page
Loading...
Need help?
General
