78
ERROR MODE
ERROR MODE
Meaning of Error Codes that LED displays during occurrence of problem.
Problem Possible Cause Solution
• Water supply is not adequate in area.
• Water supply taps are not completely open.
• Water inlet hose is bent.
• The filter of the inlet hose clogged.
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
• Drain hose is bent
or clogged.
• The drain filter is clogged.
Clean and straighten the drain
hose.
Clean the drain filter.
• Load is too small.
• Load is out of balance.
•
The appliance has an imbalance detection and
correction system. If individual heavy articles
are loaded (bath mat, bath robe, etc.) and the
imbalance is too great, after several attempts to
restart the spin cycle the machine will stop and
the error code will be displayed.
Add 1~2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
• Is the door opened or not completely
closed?
Close the door completely.
✽
If it will not open, call for service.
• Door lock is broken. Check the door switch.
• The water overfills due to a faulty water
valve.
Close the water tap.
Unplug the power plug.
Call for service.
• The water level sensor malfunction.
• Overload in motor.
Restart the cycle after 30 minutes.
If is not released, call for
service.
• Disconnection of card reader cable. Check the card reader wire.
• Too much detergent is used. This is not an error. It indicates a
suds removal routine.
It will clear and restart the cycle
when the suds are gone.
• Thermistor is opened or shorted. Thermistor should be replaced.
• Malfunction in Heater system. Check the heater and wire.
To Next Page
Loading...
Need help?
General
