36
PROGRAMMING MODE - SETUP MODE
Entering set up
mode.
You will see LqC1
Button Display
Press the
90°C (194°F)
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Display .
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press
75°C (167°F)
or
60°C (140°F)
button and then
select or
.
One or the other will
display.
Disable
Enable
Press the
Start
button.
The machine sets up the non-stop rinse, then advances
to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button three times.
9-2. Non-stop rinse
Non-stop rinse setup can be used to enable/disable simultaneous rinse & spin.
To Next Page
Loading...
Need help?
General
