28
MAGIC REMOTE CONTROL
Pairing the Magic Remote Control
You must pair the Magic remote control with the Laser TV to use it.
Pair the Magic remote control prior to use as follows:
1 Turn on the Laser TV and press the Wheel (OK) button towards the Laser TV.
When the pairing is complete, the pairing completion message is displayed on the
Laser TV screen.
2 If the remote failed to pair, turn the Laser TV off and on and try pairing again by
pressing the Wheel (OK) button.
Re-pairing the Magic Remote Control
1 Press the
HOME button and BACK button at the same time for about 5
seconds.
The Magic remote control will pair again when you press the wheel (OK) button.
2 Press the BACK button while pointing the remote control at the Laser TV for
about 5 seconds to reset and pair the remote control. When the pairing is complete,
the pairing completion message is displayed on the Laser TV screen.
Using the Magic Remote Control
1 Shake the Magic remote control lightly when there is no pointer displayed on the
screen. A pointer will be displayed on the screen.
→ The pointer disappears if the remote control is not used for a
certain period of time.
2 When you move the pointer signal transmitter up/down/left/right
while pointing it toward the Laser TV, the pointer moves.
→ If the pointer is not working properly, do not move the Magic
remote control for about 10 seconds, and then try again.
• Use the remote control within the specified range (10 meters). You may
experience communication failures when using the device outside the coverage
area or if there are obstacles within the coverage area.
• You may experience communication failures depending on nearby devices.
Devices, such as a microwave oven and wireless LAN, operate in the same
frequency band (2.4 GHz) as the Magic remote control. This may cause
communication failures.
• The Magic remote control may become damaged or may malfunction if it is
dropped or receives a heavy impact.
• Take care not to bump into nearby furniture, electronics or other people when
using the Magic remote control.
NOTE
To Next Page
Loading...
Need help?
General
