29
Setting Up the TV
Setting Up the TV
Connecting the Antenna
or Cable
To watch TV using an indoor/outdoor
antenna, connect a wall terminal and the
antenna port of the Laser TV using an
RF cable (75 Ω).
You can watch public TV or cable (analog,
digital) TV.
ANTENNA/CABLE IN
• Be careful not to bend the copper
wire when connecting the coaxial
cable (75Ω).
Fasten the cable connection
terminal by turning it clockwise.
Copper Wire
• Ensure you use a standard coaxial
cable (75Ω) when connecting to
the Laser TV input.
• To obtain better image quality in
locations where signal strength is
low, please purchase and install a
signal amplifier (booster).
• A signal splitter is required to use
one antenna to send a signal to
more than two Laser TVs.
• If you have any problems with
antenna installation, please consult
the antenna specialized retailer or
the store where you purchased the
antenna.
NOTE
To Next Page
Loading...
Need help?
General
