LG LSGL6337F - Removing the Knob Lighting PCB

3-6
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes
COMPONENT ACCESS
1. Turn off the electrical supply and gas supply going
to the range.
2. Release the knobs and Loosen 2 kinds of screws.
3. Remove the Knob ring.
4. After disconnecting the connector, remove the
PCB from the Knob ring.
REMOVING THE KNOB LIGHTING PCB
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
•
RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.