3-9
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes
1. Turn off the electrical supply and gas supply going
to the range.
2. Remove the cooktop plate (see " Removing the
cooktop plate" Page 3-4).
3. Remove the controller panel (see "Removing the
controller panel" Page 3-5).
4. Remove the back cover (see "Removing the back
cover" Page 3-2) and 2 more screws to remove
side panel.
COMPONENT ACCESS
REMOVING THE DOOR SWITCH
5. To remove the door switch:
a) Disconnect the wires frome the door switch.
b) Remove the door switch from the range.
To do this, pull while pressing both sides of the
switch.
b-2
b-1
b-1
a) Wire connector
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
•
RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.
To Next Page
Loading...
