3-16
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes
COMPONENT ACCESS
REMOVIING & REPLACING THE DRAWER
Removing the Drawer
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further
cleaning is needed. Use warm water to thoroughly
clean.
1. Fully open the drawer.
2. Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on
the right glide lever.
3. Pull the drawer away from the range.
Replacing the Drawer
1. Pull the bearing glides to the front of the chassis
glide.
2. Align the glide on each side of the drawer with the
glide slots on the range.
3. Push the drawer into the range until levers “click ”
(approximately 2 inch).
4. Pull the drawer open again to seat bearing glides
into position.
CAUTION
• Disconnect the electrical power to
the range at the main fuse or circuit
breaker panel. Failure to do so can
result in severe personal injury,
death, or electrical shock.
To Next Page
Loading...
