6
ENGLISH
ASSEMBLING AND PREPARING
Mounting on a table
1
Lift and tilt the Monitor set into its upright
position on a table.
Leave a 10 cm (minimum) space from the wall
for proper ventilation.
3
Remove 2 screws and pull out the
Stand Body
from the Monitor set.
2
Connect the
Power Cord
to a wall outlet.
10 cm
10 cm
10 cm
10 cm
Using the Kensington security system
The Kensington security system connector is
located at the back of the Monitor set. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit
http://www.kensington.com
.
Connect the Kensington security system cable
between the Monitor set and a table.
The Kensington security system is optional.
You can obtain additional accessories from
most electronics stores.
y
It's a head fixed model
and prohibited from
adjusting the angle.
y
If you try to adjust the
angle forcibly, It can be
damaged.
NOTE
WARNING