39
10 - TROUBLE SHOOTING
10.1 DURING INSTALLATION
• If the yarn feeder will not work once it has been fitted onto the machine,
(i.e. the orange lights won't light up and the motor won't run), check to see
that the flat strip power cable has been connected correctly (par. 2.1
refers). Try loosening and reconnecting the feeder back onto the power
cable once again. If it doesn't start up, try moving the fixing point on the
power cable 1 cm away to the side.
If, after having tried the above options the feeder still doesn't start up, it
must be replaced due to a probable failure of the main control board.
10.2 DURING OPERATION
• If after having functioned correctly, the feeder's orange signal lights won't
light up when the machine stops, check to see whether the lights are still
working correctly.
• If any failure by the feeder were not caused by incorrect installation or by
connection errors, there probably is a failure in the main control board. In
these cases the yarn feeder must be replaced and the repair operations
must be carried out by regularly authorised L.G.L. personnel.
To Next Page
Loading...